Klarstein 10030628 Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

• Set the ON/OFF switch 3 to position HEAT. The indicator lamp lights up. Preheat the device at least 15-20
minutes prior to use.
Melting the chocolate coating
• Melt the chocolate coating in a water bath.
• Note: Make sure that no water enters the chocolate coating. Lumps may form otherwise.
Using the device
• Pour the melted chocolate coating into the filling trough. Do not overfill! Add some vegetable oil if the
melted chocolate is too thick.
• Set the ON/OFF switch 3 to position HEAT/MOTOR. The conveyor screw begins to move. The chocolate is
transported upward through the cylinder and flows down over the umbrellas into the filling trough.
• Dip foods with skewers into the melted chocolate.
Note: The device can be run continuously for several hours without problems.
After using the device
• Set the ON/OFF switch to position OFF.
• Clean the device immediately and pour out excess chocolate (see "Care and maintenance").
Other possible applications
• Refine the chocolate, e.g. with liqueur.
• You can use cheese or barbecue sauces instead of chocolate. Add vegetable oil to ensure ease of flow. For
dipping, you can use, e.g. asparagus, sausages, grill food.
12

Publicidad

Tabla de contenido
loading

Tabla de contenido