What Water To Use - Rowenta PRO PERFECT CONTROL DG8790F0 Manual De Instrucciones

DESCRIPTION
1.
Iron handle
2.
a. Turbo steam button
b. Turbo steam button: left/right
rotary trigger
3.
Steam control button
4.
Iron rest
5.
Removable 1.4 L water tank
6.
Scale collector cover
7.
Power cord
8.
Power cord storage
9.
Iron positioning system
10.
Steam cord
11.
Steam cord storage clip
PREPARATION
1 • What water to use ?
Your appliance has been designed to
operate with untreated tap water.
If your water is very hard (check with
your local water authority) it is possible
to mix untreated tap water with store-
bought distilled or demineralised water
in the following proportions: 50%
untreated tap water, 50% distilled or
demineralised water.
TYPES OF WATER NOT TO USE: Heat
concentrates the elements contained in
water during evaporation. The types of
water listed below may contain organic
waste, mineral or chemical elements that
can cause spitting, brown staining, or
premature wear of the appliance: water
from clothes dryers, scented or softened
water, water from refigerators, batteries,
air conditioners, rain water, boiled,
filtered or bottled water. Also only use
distilled or demineralised water as
advised above.
12.
"Calc-Away System" scale collector
13.
Illuminated on / off switch
14.
Control panel
a. Fabric type selector
b. "Steam ready" indicators
c. "Temperature ready" indicators
d. "Calc-away" indicator and Restart
button
e. "Auto-off" indicator
and Restart button
f. "Water empty" indicator and
Restart button
g. Position cursor
2 • Preparing your steam
generator
Place the steam generator on a flat,
stable, heat-resistant surface.
Remove the water tank using the handle
(on the front of the steam generator)
fig.12.
Fill the tank with untreated tap water,
taking care not to exceed the maximum
level - fig.1.
Slide the tank back into its housing until
its "clicks" into place.
Unwind the electrical power cord
completely and remove the steam cord
from its housing
Plug your steam generator into a mains
socket with an earth pin
For best results you should use a mesh
type/vented ironing board.
4
- fig.2.
- fig.3.
-