What Water To Use - Rowenta DW4000 Instructivo De Operación

mental capabilities or lack of expe-
rience and knowledge prevents
them from using the appliance sa-
fely without supervision or instruc-
tion by a responsible person to
ensure that they can use the ap-
pliance safely.
13. Children should be supervised
by the responsible person to en-
sure that they do not play with the
appliance.
SPECI L INSTRUCTIONS
17. The iron must not be left unat-
tend while it is connected to supply
mains.
S VE THESE INSTRUCTIONS

What water to use?

Your appliance has been designed to function
with untreated tap water. If your water is very hard
(check with your local water authority), it is
possible to mix untreated tap water with store-
bought distilled or demineralised water in the
following proportions: - 50% tap water, - 50%
distilled or demineralised water.
However, it is necessary to operate the Self-Clean
function regularly in order to eliminate hard
water deposits from the steam chamber.
Use the self-clean function approximately every
2 weeks. If the water is very hard clean the iron
weekly
Types of water not to use?
Heat concentrates the elements contained in
water during evaporation.The types of water
listed below contain organic waste or mineral
elements that can cause spitting, brown staining,
or premature wear of the appliance: water from
clothes dryers, scented or softened water, water
from refrigerators, batteries or air conditioners,
pure distilled or demineralised water or rain water
should not be used in your Rowenta iron. lso do
not use boiled, filtered or bottled water.
All manuals and user guides at all-guides.com
14. the iron must be used and res-
ted on a stable surface;
15. when placing the iron on its
stand, ensure that the surface on
which the stand is placed is stable;
16. the iron is not to be used if it
has been dropped, if there are visi-
ble signs of damage or if it
is leaking.
18. lways disconect the iron from
the electrical outlet, before you
leave the room.
cut-out (depending on model)
If, although switched on, the appliance is not
moved, it will automatically switch off and the
auto off light will blink after the following
intervals:
-
the soleplate or lying on its side.
-
heel.
To switch the iron back on, move the iron gently.
Your iron is equipped with the utosteam system,
it automatically adjusts the steam amount and the
temperature based on the selected fabric.
For steam ironing, push the steam lever to
UTOSTE M position. Select the fabric to be
ironed on the thermostat dial.
You can also set your iron based on the
international temperature measurements.
For each fabric, the iron will automatically adjust
the steam rate for optimum performance.
For dry ironing, set the steam lever on DRY
position.
13
utomatic 3-position
fter 30 sec., if the iron is left placed down on
fter 8 mins., if the iron is left standing on its
utosteam
EN
FR
ES