Locking The Remote Controller Buttons (Operation Function Limit Controller) - Mitsubishi Electric PAR-W21MAA Manual De Instrucciones

(3) Locking the Remote Controller Buttons (Operation function limit
controller)
If you wish, you can lock the remote controller buttons. You can use the Function
Selection of remote controller to select which type of lock to use. (For information
about selecting the lock type, see section 6, item [4]–2 (1)).
Specifically, you can use either of the following two lock types.
1 Lock All Buttons : Locks all of the buttons on the remote controller.
2 Lock All Except ON/OFF : Locks all buttons other than the ON/OFF button.
Note:
The "Locked" indicator appears on the screen to indicate that buttons are currently
locked.
<How to Lock the Buttons>
1. While holding down the CIR.WATER
OFF button 1 for 2 seconds. The "Locked" indication appears on the screen (at
1), indicating that the lock is now engaged.
* If locking has been disabled in Function Selection of remote controller, the
screen will display the "Not Available" message when you press the buttons as
described above.
• If you press a locked button, the "Locked" indication (at 1) will blink on the
display.
Lock Indicator
<How to Unlock the Buttons>
1. While holding down the CIR.WATER
OFF button 1 for 2 seconds—so that the "Locked" indication disappears from the
screen (at 1).
– 15 –
button 4, press and hold down the ON/
button 4, press and hold down the ON/