Parts & Assembly - Nostalgia Products CFF552 Instrucciones Y Recetas

PARTS & ASSEMBLY
Your STAINLESS STEEL CHOCOLATE FONDUE FOUNTAIN requires little
assembly. Prior to use, wipe out Bowl with a damp cloth and dry.
Wash Auger and Tower in warm, soapy water, rinse, then dry.
Tower
After cleaning, assemble fountain by following these steps:
• Attach Bowl to top of Base by aligning the notches in the bottom of
the Bowl to the notches on top of Base and securing in place.
• Make sure Auger is securely in place by aligning the
opening on the bottom of the Auger with the Base Pin.
• Attach Tower to Bowl by aligning the holes in the
bottom of the Tower with the pins in the Bowl.
• Place Tower Bowl on top of Tower.
DO NOT attempt to place Auger or Tower on Base or remove from Base while the
motor is running. Make sure the Tower is fitted on the posts in the Base properly.
Bowl
Auger
Base
6