Cub Cadet RZT SX Serie Manual Del Operador página 17

Note: This Operator's Manual covers several models.
Tractor features may vary by model. Not all features
in this manual are applicable to all tractor models
and the tractor depicted may differ from yours.
WARNING
Before performing any maintenance or repairs, disengage
the PTO, move the drive control levers fully outward in
the neutral position engaging the parking brake, stop the
engine and remove the key to prevent unintended starting.
Post-Operation Tractor Care
After each operation of the tractor, the following
procedures should be implemented to extend the life
of your tractor and ensure safe operating conditions.
DANGER
Failure to follow these recommendations may result in
serious injury to yourself or others and may cause damage
to the tractor.
Cleaning the Underside of the Deck
Deck Wash System
Your tractor's deck is equipped with a water port
on its surface as part of its deck wash system.
Use the deck wash system to rinse grass clippings
from the deck's underside and prevent the buildup
of corrosive chemicals. Complete the following steps
AFTER EACH MOWING:
1. Attach the nozzle adapter to a standard
garden hose connected to a water supply.
2. Move the tractor to an area within reach of the
hose where the dispersal of wet grass clippings
is acceptable to you. Disengage the PTO,
engage the parking brake and stop the engine.
3. Pull back the lock collar (a) of the nozzle
adapter (b) and push the nozzle adapter (b)
onto one of the deck wash nozzles (c) at either
end of the tractor deck. Release the lock collar
(a) to lock the nozzle adapter (b) on the deck
wash nozzle (c). See Figure 4-1.
(b)
(a)
(c)
Figure 4-1
4. Turn on the water supply.
5. From the tractor operator's seat, start the
engine and engage the PTO. Allow to run
as needed. Disengage the PTO and stop the
engine.
6. Turn off the water supply.
7. Pull back the lock collar (a) of the nozzle
adapter (b) to disconnect the nozzle adapter
(b) from the deck wash nozzle (c).
8. Repeat the previous steps to clean the deck
using the deck wash nozzle (c) at the other
end of the deck.
Cleaning the Tractor
WARNING
If the tractor has been recently run, the engine, muffler and
surrounding metal surfaces will be hot and can cause burns
to the skin. Let the engine cool for at least five minutes
Exercise caution to avoid burns.
Your tractor should be cleaned after each use and
under certain conditions, i.e. dry conditions and/
or mulching situations, additional cleaning may be
necessary.
One of the best ways to keep your tractor running
efficiently and to reduce fire risk is to regularly
remove debris buildup from the tractor. Follow
the recommendations below and contact your
authorized dealer with any questions.
• Allow the machine to cool in an open area
before cleaning.
• Do not use water on any part of the tractor
except the underside of the cutting deck.
Doing so can cause damage to the tractor's
spindle bearings, electrical system and
engine, leading to premature failures. The
use of compressed air and/or leaf blower
will help keep the tractor clean.
• Keep both sides of transmission cooling
slots, exhaust manifold, around fuses, all
wiring and harnesses, muffler pipe, muffler
shield, engine intake screens and cooling
fins, etc clear of grass clippings and leaves.
See Figure 4-2.
Engine/Seat Not Shown for Clarity
Figure 4-2
• Clean the top of the mower deck, under the
spindle covers and belt area. See Figure 4-3.
Figure 4-3
• Clean around and near the transmission,
axle and the fan area. See Figure 4-4.
Wheel Not Shown For Clarity
Figure 4-4
• Debris can accumulate anywhere on the
tractor, especially on horizontal surfaces.
Additional cleaning may be necessary
when mowing in dry conditions or when
mulching.
• Fuel leaks/spills, oil leaks/spills and excess
lubrication can also become collections sites
for debris. Immediate repair and cleaning up
oil or fuel spills can help reduce fire hazards.
• In addition to cleaning the tractor before
operating and storing, do not attempt to
mow unusually tall grass (10" or higher), dry
grass (e.g., pasture) or piles of dry leaves.
Dry grass or leaves may contact the engine
exhaust and/or build up on the mower deck
presenting a potential fire hazard.
Storing the Tractor
• Allow the machine to cool in an open area
before storing.
• Do not park the tractor near any flammable
materials (wood, cloth or chemicals) or any
open flames or other potential source of
ignition (furnace, water heater or any other
type of heater).
• Remove all combustible materials from the
tractor before storing. Empty cargo boxes,
grass catchers or containers.
• Always shut off fuel flow when storing or
transporting if tractor is equipped with a
fuel shutoff.
• Check the fuel system (lines, tank, cap and
fittings) frequently for cracks or leaks. Repair
and clean as necessary.
S 4 — P
ection roduct
c 17
are