Cub Cadet RZT SX Serie Manual Del Operador página 8

Console Inside
Figure 2-5
9. Secure the console in place with the six
shoulder screws. See Figure 2-6. Torque the
shoulder screws to 60 in/lbs (+/- 20%).
Figure 2-6
Note: Do not overtighten the shoulder
screws. Doing so can cause damage to the
console.
Steering Wheel (If necessary)
1. Remove the hardware for attaching the
steering wheel (a) from beneath the
steering wheel cover (b). Carefully pry off
the steering wheel cover (b) to remove the
hardware. See Figure 2-7.
(b)
(e)
(a)
(d)
(c)
Figure 2-7
2. With the wheels of the tractor pointing
straight forward, place the steering wheel
(a) over the steering shaft (c). See Figure 2-7.
8 S 2 — A
ection SSembly
3. Place the belleville washer (d) over the
steering wheel (a) and secure with the hex
screw (e). See Figure 2-7.
4. Place the steering wheel cover (b) over the
center of the steering wheel (a) and push
downward until it "clicks" into place. See
Figure 2-7.
Install Operator's Seat
Seat Pan attached to Seat
Cover
To install the seat proceed as follows:
1. Cut any straps securing the seat assembly to
the tractor. Remove any packing material.
Note: Be careful not to cut the seat switch
wiring harness.
2. Remove the two shoulder screws (a) and
flange lock nuts (b) in the seat pan as shown
in Figure 2-8.
(a)
3. Rotate the seat into position and secure the
seat into place with the previously removed
shoulder screws (a) and flange lock nuts (b).
Be careful not to crimp or damage the wire
harness while installing the seat. See Figure 2-9.
(a)
& S -U
et p
(b)
(b)
(a)
Figure 2-8
(b)
(b)
(a)
Figure 2-9
4. If necessary, securely connect the seat switch
wiring harness (a) to the seat switch (b) as
shown in Figure 2-10 . Be sure to push the
excess wire from the wire harness into the
seat box hole (c) before continuing.
(b)
(a)
(c)
Figure 2-10
Note: The tractor will not operate without
the seat switch wiring harness in place.
Seat Pan attached to Tractor
To install the seat proceed as follows:
1. Cut any straps securing the seat assembly to
the tractor. Remove any packing material.
Note: Be careful not to cut the seat wiring
harness.
2. Using the four provided bolts (a), install the
seat onto the seat pan. Place the screws (b)on
the front of the seat through the middle hole
in the seat pan (c) as shown in Figure 2-11.
Securely tighten the seat to the seat pan.
Figure 2-11
(a)