Battery Installation/Replacement; Setting The Date/Time - HealthSmart 04-775-001 Manual De Instrucciones

Battery Installation/Replacement

symbol appears on the display, Fig. 1, or when the
Replace the batteries when the Low Battery
display remains blank when the POWER
Button is pressed.
To change the batteries:
1. Open the battery cover, Fig. 2.
install two AAA alkaline batteries, Fig. 3.
2. Making sure the battery polarity is correct,
3. Close the battery cover, Fig. 4.
NOTE: It is recommended to remove the batteries if the unit will not be
used for an extended period of time.
Fig. 2
Fig. 3
Fig. 1
Fig. 4
10

Setting the Date/Time

NOTE: When the unit is off, the date and time will still appear at the top
of the screen.
ORY button at the same time. The month will begin to flash, Fig. 1.
1. When the unit is off, press and release both the POWER and MEM-
2. Press the MEMORY button to change until the desired number
appears.
NOTE: To scroll through the numbers quicker, hold down the
MEMORY button.
3. Press the POWER button to set the entry.
4. The date, Fig. 2, followed by the hour and minutes will blink. Repeat
steps 2 and 3 to adjust the date/time setting.
the date/time setting mode, Fig. 3.
5. After setting the minutes, the unit will automatically exit out of
NOTE: The time is expressed in 24hr military time. The chart below
explains the time conversion.
Regular Time Military Time
(12 hours) (24 hours)
12 am
0
Midnight
1 am 1
2 am 2
3 am 3
4 am 4
5 am 5
6 am 6
7 am 7
8 am 8
9 am 9
10 am 10
11 am 11
Regular Time Military Time
(12 hours) (24 hours)
12 pm
12
Noon
1 pm 13
2 pm 14
3 pm 15
4 pm 16
5 pm 17
6 pm 18
7 pm 19
8 pm 20
9 pm 21
10 pm 22
11 pm 23
11
Fig. 1
Fig. 2
Fig. 3