Battery Installation/Replacement; Setting The Date/Time - HealthSmart 04–825–001 Manual De Instrucciones

Battery installation/rePlacement

Replace the batteries when the Low Battery symbol appears
on the display, Fig. 1, or when the display remains blank when
the POWER Button is pressed.
To change the batteries:
1. Open the battery cover, Fig. 2.
2. Making sure the battery polarity is correct, install 2 AAA alkaline
batteries, Fig. 3.
3. Close the battery cover, Fig. 4. The monitor, the batteries and the cuff,
must be disposed of according to local regulations at the end of their usage.
The monitor, the batteries and the cuff, must be disposed of according
to local regulations at the end of their usage.
NOTE: It is recommended to remove the batteries if the unit will not be used for an
extended period of time. Rechargeable batteries are not suitable for this monitor.
Fig. 2
04-825-001 IM_13Feb2015.indd 12-13
Fig. 1
Fig. 4
Fig. 3
12
setting the Date / time
NOTE: When the unit is off, the date and time will still appear at
the top of the screen.
1. When the unit is off, press both the POWER and
MEMORY button at the same time for 2 seconds. The
month will begin to flash, Fig. 1.
2. Press and hold the MEMORY button until the desired
number appears.
3. Press the POWER button to set the entry.
4. The date, Fig. 2, followed by the hour and minutes will
flash. Repeat Steps 2 and 3 to adjust the date/time
setting.
5. After setting the minutes, the unit will automatically exit
out of the date/time setting mode, Fig. 3.
NOTE: The time is expressed in 24-hour military time. The chart
below shows the time conversion.
Regular Time Military Time Regular Time
(12 hours) (24 hours) (12 hours)
12 am
0
Midnight
1 am 1
2 am 2
3 am 3
4 am 4
5 am 5
6 am 6
7 am 7
8 am 8
9 am 9
10 am 10
11 am 11
Fig. 1
Fig. 2
Fig. 3
Military Time
(24 hours)
12 pm
12
Noon
1 pm 13
2 pm 14
3 pm 15
4 pm 16
5 pm 17
6 pm 18
7 pm 19
8 pm 20
9 pm 21
10 pm 22
11 pm 23
13
2/13/15 5:18 PM