ROBBE Power Peak Twin EQ-BID Manual De Uso página 54

The following table explains the individual user selection options:
Select
AUTOMATIC
NORMAL
LINEAR
REFLEX
CC-CV
C>D
D>C
1 x
10 M
Operating Instructions
Power Peak ® Twin EQ-BID
Order of the process
In automatic mode, the charger will automatically set the opti-
mum charge-/discharge current. It only requires the cut-off tem-
perature to be set when using the temperature sensor.
The charger works with user set charge as well as discharge
parameters in this mode. The voltage state of the battery will be
checked every minute.
The charger works with user set charge as well as discharge
parameters in this mode. The battery is charged at a constant
current.
The charger works with user set charge as well as discharge
parameters in this mode. The battery is charged with a pulsed
constant current. Using a powerful, very short timed discharge
impulse, the undesirable memory- and lazy battery - effects will
be minimised when charging NiCd and NiMH batteries.
This charge procedure is used for lithium and lead batteries. It
will be charges with a constant current and then with a constant
voltage (see illustration on page 26).
This option defines the sequence of the cycle, the sequence
starts with a charge process, and then, finally, the battery will
be discharged.
This option defines the sequence of the cycle, the sequence
starts with a discharge process, and then, finally, the battery
will be charged.
Number of cycles
Cycle pause in between a charge and discharging operation
20