TEFAL EXPRESS BOIL BR400870 Manual De Instrucciones página 7

• Put your appliance on a dry, flat, stable, heat-resistant secure surface away from
the edge.
• Plug the appliance into a mains socket.
IMPORTANT:
Press the stop button immediately to ensure that the appliance does not start a
heating cycle without water in the tank or without a cup under the spout
• Follow the instructions below on using your appliance and carefully discard the first
five measures of boiled water (i.e. the first full tank of water). This will remove any
residues that may remain from the manufacturing process.
Using your appliance
1. Press the lid open button
2. Fill the water tank B with cold tap water either directly from your cold water tap or
using a jug filled with fresh cold water from the tap
The water level should be between the min and max markings. You can see the level
through the water window.
3. Close the lid with button G.
4. Press the stop button (D). This will make sure that your appliance will not
immediately start a heating cycle when you place it onto the power base.
5. Place a suitable cup or container with a tea bag or coffee, sugar, etc. below the
dispensing nozzle (C).
6. Select the desired volume of hot water by adjusting the dispensing control knob to
the required setting
For small cups (around 150ml), set the control towards the
For large cups (around 250ml), set the control towards the
If you are not sure which setting to use, it's best to use a lower setting the first time.
7. Press the start button (E). The start button lights up red and your appliance starts
to boil. (Fig 5).
8. If, after just having heated up and dispensed water the appliance will not switch
back on and heat up again straightaway for the next cup, simply wait for a few
seconds before pressing the start button again.
H (fig 1)
(fig 3)
F (fig 4).
The selected quantity of hot water will be dispensed into the cup.
(fig 2).
setting.
setting.
EN
3