Brandson Equipment 303320 Manual Del Usuario página 26

5. Installation
Take the appliance out of the packaging and remove any packaging material and
check the appliance for any damage. The fan heater must be placed on a flat sur-
face. Ensure that the heater is placed at least 1m away from other objects, and
not directly below a socket. A socket should be available for supplying power to
the appliance.
Caution! Ensure that the appliance is not placed near any flammable materials or
fluids, or with the air discharge pointing in these directions.
Note: To ensure that the heater works and heats properly, the desired temper-
ature must be set on the heater so that it is a couple of degrees higher than the
room temperature. If the heater does not seem to be heating, increase the desired
temperature on the heater to activate the heating elements.
6. Commissioning
Connect the appliance to a 220-240V AC socket. Set the ON/OFF switch at the back
of the appliance to position "I" to start the appliance. The heater then shows the
current temperature in the display. To switch off the appliance, set the "ON/OFF"
switch to the "0" position.
Press the " " button on the control panel at the front of the fan. The ventilation
starts now.
The appliance has two different heat settings. The heat settings are shown in the
form of two suns in the display (see Chapter 4 under "Product details"). Press the
mode button " " to select heat setting 1 or heat setting 2. Press the button once
to switch on heat setting 1, twice to switch on heat setting 2, and a third time to
change to ventilation mode.
Thermostat function
Press the temperature button " " to set a desired temperature. Temperatures
between 10°C and 35°C can be set. As soon as the set temperature is less than or
equal to the current air temperature, the heating function is switched off. The fan
does not switch off and maintains the set temperature.
26
English