Brandson Equipment 303320 Manual Del Usuario página 27

If the set temperature is 2°C more than the current air temperature, then heat
setting 1 (" " symbol in the display) switches on and starts heating until the
room temperature reaches the desired temperature. If the set temperature is
4°C or more than the current room temperature, the heat setting 2 (two " "
symbols in the display) switches on and heats the room to the set temperature.
Timer function
Press the " " button to switch on the timer. The timer function works in all the
modes. Every time you press the timer button, the value increments by one hour,
up to a maximum of 8 hours. Press the timer button again to reset the timer.
If the timer is set once, the countdown function starts counting down and switches
off the appliance at the end of the timer count.
7. Overheating
Overheating generally occurs only if one of the openings of the fan heater is
blocked. This device comes with a non self-resetting thermal fuse. The heater
switches off automatically once the overheating temperature is reached. The fan
heater can be operated again only after the fuse is replaced by the manufacturer
or by an equally qualified person.
8. Oscillation
The oscillation of the appliance can be switched on or off using the " " button.
9. Cleaning and Care
Completely switch off the appliance and disconnect it from the power supply
before you start cleaning it.
Clean the housing with a slightly damp cloth, a vacuum cleaner or a dusting
brush. Never use flammable, aggressive or scouring cleaning agents such as
benzene or spirit to clean.
Clean the air inlet and outlet regularly using a vacuum cleaner.
If the appliance is not going to be used for a long time, then it must be protected
against excessive dust and dirt.
27
English