Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3
ADJUST HOT LIMIT STOP
HOT LIMIT SAFETY STOP ADJUSTMENT
• By restricting HANDLE rotation and limiting the
amount of hot water allowed to mix with the cold,
the HOT LIMIT STOP (1) reduces risk of accidental
scalding. To set the maximum hot water temperature
of your faucet, all you need to do is adjust the setting
on the HOT LIMIT STOP (1).
• Turn CARTRIDGE STEM (2) to the OFF position
(coldest setting) before making adjustment to HOT
LIMIT STOP (1). Use a flat blade screwdriver to pry
free the HOT LIMIT STOP (1). Pull forward and rotate
counterclockwise to limit hot water temperature.
Use ARROW (3) on CARTRIDGE (4) and NUMBERS (5)
on HOT LIMIT STOP (1) for indication.
4
HANDLE INSTALLATION
• Install HANDLE (1) by pushing it onto CARTRIDGE STEM (2)
and tightening SET SCREW (3) from below with 2.5 mm
Hex Wrench supplied.
5
SERVICE
• If faucet drips, operate handle several times from "off"
to "on". Do not apply excessive force.
• Clogged CARTRIDGE (4) inlets may cause reduced flow
in "full on" hot or cold. To clean inlets, first turn off water
supply, then:
– Remove HANDLE (1), CAP (2) and CARTRIDGE (4).
Clean inlets and MANIFOLD (5).
– Reassemble CARTRIDGE (4), alternately tightening
SCREWS (3).
– Replace CAP (2) and HANDLE (1). Check flow.
6
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
2
3
COLDER
4
(Larger Numbers)
MÁS FRÍA
(números mayores)
0 1 3 5 7 9 11 13 15
2.5 MM HEX
WRENCH
4
5
- 3 -
3
5
1
4
HOTTER
2
(Smaller Numbers)
MÁS CALIENTE
(números menores)
0 1 3 5 7 9 11 13 15
5
1
2
1
3
1
2
3
M965762 (8/16)
Publicidad
Tabla de contenido
