Trim Installation; Handle Installation - American Standard Times Square Flash TU184740 Instrucciones De Instalación

1

TRIM INSTALLATION

• Remove PLASTER GUARD (1) and the two
CARTRIDGE COVERS (2).
• Push two CARTRIDGE SLEEVES (3) over the
cartridges on VALVE BODY (4).
• Push ESCUTCHEON HOLDER (5) over
CARTRIDGE SLEEVES (3).
• Insert four SCREWS (7) through MOUNTING
PLATE (6) and ESCUTCHEON HOLDER (5)
and thread in to VALVE BODY (4) where
indicated by a dashed line.
• Push ESCUTCHEON (8) on to MOUNTING
PLATE (6) until they are secured with the
snap fitting.
2
TRIM INSTALLATION FOR THIN WALL
• Remove the two CARTRIDGE COVERS (2).
• Push two CARTRIDGE SLEEVES (3) over
the cartridges on VALVE BODY (4).
• Remove the four PLASTER GUARD
SCREWS (1).
• Push ESCUTCHEON HOLDER (5) over
CARTRIDGE SLEEVES (3).
• Insert four SCREWS (7) through MOUNTING
PLATE (6), ESCUTCHEON HOLDER (5), and
PLASTER GUARD (9) and thread in to the
VALVE BODY (4) where indicated by a
dashed line.
• Push ESCUTCHEON (8) on to MOUNTING
PLATE (6) until they are secured with the
snap fitting.
3

HANDLE INSTALLATION

• Push the two HANDLE ADAPTERS (1) on to VALVE
STEMS (6) and secure with HANDLE ADAPTER
SCREWS (2).
• Push the two HANDLES (3) over HANDLE
ADAPTERS (1).
• Secure the two HANDLES (3) with SET SCREWS (4)
and the provided HEX WRENCH (5).
NOTE: Adjust the orientation of HANDLE ADAPTER (1)
to align handles at the 6 o'clock position as pictured.
4
3
1
4
3
9
- 2 -
1
5
7
6
5
7
6
6
1
2
4
5
2
8
2
8
3
M985083 (1/21)