Handle Installation - American Standard Quentin TU440507 Instrucciones De Instalación

2
STANDARD WALL INSTALLATION
• Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
THIN WALL INSTALLATION
• Figure 1a. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2a. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
PLASTER
GUARD
Figure 1.
Figure 1a.
3
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
Protect finish on SHOWER HEAD
CAUTION
and TUB SPOUT when installing.
• Remove pipe cap and plug from shower and tub
rough piping.
• Slip TUB SPOUT (1) onto tub nipple and tighten with
4 mm Hex Wrench.
• Apply Teflon Tape to both ends of SHOWER ARM (2).
• Install SHOWER ARM (2) with FLANGE (3) into shower
pipe and tighten.
• Thread SHOWER HEAD (4) onto ARM (2) and tighten.
• Push SHOWER ARM FLANGE (3) to wall and tighten SET
SCREW (5) with 5/64" hex wrench.
4

HANDLE INSTALLATION

• Install HANDLE (1) by pushing it onto CARTRIDGE STEM (2)
and tightening SET SCREW (3) from below with 2.5 mm
Hex Wrench supplied.
1
2
2
1
4
- 2 -
1
Figure 2.
1
Figure 2a.
PIPE PLUG
3
2
PIPE
CAP
1
1
3
4
H
C
F F
O
3
4
H
C
F F
O
SHR.
ELBOW
5
HEX
WRENCH
TEFLON TAPE
TUB FILLER
NIPPLE
F .
R E
/ 2 "
1 - 1
4MM HEX
WRENCH
2
H
C
3
2.5 MM HEX
WRENCH
M965936 Rev. 1.1 (3/20)