Care And Cleaning - Kenwood SB260 Serie Instrucciones

hints
G
To make a thinner smoothie drink
add more liquid.
G
To make a thicker smoothie drink
add more frozen ingredients but
do not exceed the frozen limit
marked on the goblet.
G
Before fitting the lid, push the solid
ingredients into the liquid using the
stirrer.
G
Use the pulse 'P' button to
operate the power unit in a start
stop action to control the texture
of your drink. Take care as this
automatically selects the higher
speed and may cause the drink to
be thrown up the sides and onto
the lid of the goblet.
G
After blending, some drinks may
not be completely smooth due to
seeds or the fibrous nature of
ingredients.
G
Some drinks may separate on
standing, therefore, it's best to
drink them straight away.
Separated drinks should be stirred
before drinking.
important
G
Never blend more than the
maximum capacity of 1500ml
marked on the goblet.
G
Never blend dry ingredients (eg
spices, nuts) or run the Smoothie
Blender empty.
G
Don't use the Smoothie Blender
as a storage container. Keep it
empty before and after use.
G
Some liquids increase in volume
and froth during blending eg milk,
so do not overfill and ensure the lid
is correctly fitted.
G
To ensure long life of your
Smoothie Blender, never run it
continuously for longer than 60
seconds.
G
Never blend food that has formed
a solid mass during freezing, break
it up before adding to the goblet.

care and cleaning

G
Always switch off, unplug and
dismantle before cleaning.
G
Never let the power unit, cord or
plug get wet.
G
Empty the goblet before
unscrewing the blade unit.
G
Always wash immediately after
use. Don't let food dry onto the
goblet assembly as this will make
cleaning difficult.
G
Don't wash any part in the
dishwasher.
G
Regularly dismantle the tap and
clean the parts thoroughly.
Smoothie Blender unit
Before dismantling the Smoothie
Blender, half fill the goblet with
warm water. Fit the lid and stirrer
then place on the power unit.
Switch to low ' ' and whilst
running open the tap and allow the
water to drain into a container to
clean the valve. This can be
repeated until the water runs clear.
If further cleaning is necessary
dismantle the unit first.
power unit
G
Wipe with a damp cloth, then dry.
G
Push excess cord into the back of
the power unit.
blade unit
1 Remove and wash the sealing ring.
2 Don't touch the sharp blades -
brush them clean using hot soapy
water, then rinse thoroughly under
the tap. Don't immerse the blade
assembly in water.
3 Leave to dry upside down away
from children.
goblet, lid, cap and stirrer
Wash by hand, rinse with clean
water then dry.
cleaning the tap
Remove the tap assembly from the
goblet, then soak the tap in hot
soapy water with the valve open
. Wash thoroughly then rinse and
dry. Wash and dry the goblet then
refit the tap ensuring that the seal
is correctly positioned on the goblet
.
5