General Cleaning And Maintenance Work; Replacing The Rechargeable Battery; Replacing The Blades; Updating The Firmware - Grizzly MR 1000 Traducción Del Manual De Instrucciones Original

GB
Before any maintenance or clean-
ing work, switch off the device and
wait for the blade to come to a
standstill.
Wear gloves when handling the
blades.
General cleaning and
maintenance work
Never spray down the lawn
mower with water. There is a
risk of electric shock.
• Keep the device clean. Use a brush
or cloth for cleaning, but do not use
any aggressive cleaning agents or sol-
vents.
• Grease the wheels from time to time.
• Check the covers and protective de-
vices for damage and correct fit. Re-
place these if necessary.
Replacing the
rechargeable battery
Switch off the device and wait
for the blades to come to a stop.
There is a risk of personal injury.
There is a risk of injury from
leaking battery fluid! In case of
contact with eyes or skin, rinse
the affected sites with water or
a neutralising agent and seek
medical attention.
1. Turn over the automatic lawn mower.
2. Open the battery compartment
( 32) by removing the 6 screws on
the underside of the device.
3. Remove the battery (24).
88
4. Insert the new rechargeable battery.
5. Re-connect the battery compartment.

Replacing the blades

If the blades are blunt, damaged or show
signs of imbalance, they need to be re-
placed (see "Spare parts/accessories").
1. Turn the device over.
2. Remove the blade bolts (27) on the
underside of the device and remove
the old blades (26).
3. Fasten the new blades (26) with the
blade bolts (27).

Updating the firmware

Firmware updates can be performed by
one of our service partners (see "Service
Centre").

Storage

• Store the device in a dry place, out of
reach of children.
• Do not enclose the device in nylon
sacks as this may cause moisture to
form.
We are not liable for damage cause by
our devices if this is caused by improper
repair, the use of non-original parts or in-
correct use.

Storage over winter

• Clean the device prior to storage (see
"Cleaning and maintenance").
• Make sure that the on/off switch (5) on
the device is set to "Off".
• Only store the batteries in the partially-
charged state. The charge status