Trouble Shooting - Grizzly MR 1000 Traducción Del Manual De Instrucciones Original

Trouble Shooting

Problem
Device does not
start
Engine switches
off
Device rotates
incessantly on
the lawn area
Automatic lawn
mower moves,
but does not cut
Output not satis-
factory or engine
is difficult to op-
erate
Abnormal
sounds, clatter-
ing or vibrations
Possible cause
On/Off switch (
"Off" ("0" position)
Rechargeable battery not in-
serted
Defective motor
Grass too long
Blockage by foreign body
Boundary wire (
damaged
Defective battery
Cutting height too low
Blades ( 26) blunt
Blade area blocked
Blades ( 26) incorrectly as-
sembled
Blade bolts ( 27)
loose
Blades damaged (
Troubleshooting
Set the on/off switch (
5) set to
"On" (position "1") (see "Switch-
ing on and off")
Insert rechargeable battery (see
"Replacing the rechargeable bat-
tery")
Send the device in to the Service
Centre for repair
Pre-mow the lawn area if neces-
sary.
Set higher cutting height.
Remove foreign body
6) cut or
Repair the boundary wire (
Replace the rechargeable bat-
tery (see "Replacement parts/
accessories)
Set higher cutting height
Sharpen or replace blades
Clean device
Install blades correctly
Tighten blade bolts
Replace blades
26)
GB
5) to
6)
91