Cooper Lighting TQS1000 Manual De Instrucciones página 3

TQS1000325-1533.qxd
• The electrical system, and the method of electrically connecting the fixture
to it, must be in accordance with the National Electrical Code and local
building codes.
• Do not operate the unit with a missing or damaged wire safety guard, safety
glass lens (lamp containment), or UV filter.
• Do not direct the light at persons or look directly at lighted fixture.
• Use only with a 500 watt or smaller bulb. Installing a bulb of a higher
wattage could create a fire hazard. Use of a higher wattage bulb will
void the warranty.
• Never touch the bulb with your bare hands. Oil from your skin can cause pre
mature failure. Always handle the bulb with gloves or a soft
• If lens is replaced, use only a diffused tempered safety glass of equal thickness.
• For maximum bulb life, position light so that the quartz halogen bulb remains
within 4 degree of horizontal.
• Disassembly of your fixture will void the warranty.
Warning: When using outdoor use portable lamps, basic safety
precautions should always be followed to reduce the risk of fire,
electric shock and personal injury, including the following...
• Use only with three wire extension cords that have three-prong gorunding
plugs and that are suitable for outdoor use, such as cords marked SW, SW-A,
SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW,
SJOW-A, SJTW-A, SJTOW, SJTOW-A and grounding receptacles that accept
a three-prong plug. When the fixture is used in wet locations, Ground Fault
Circuit Interruption (GFCI) protection must be provided o the circuit(s) or out
let(s) to be used. Receptacles are available having built-in GFCI protection
and are able to be used for this measure of safety.
Warning: Deviation from the assembly instructions may result in a
risk of fire or electric shock.
SAVE THESE INSTRUCTIONS.
Assembling your fixture
Step 1: Remove pole and leg assembly from box.
Unlock legs first by pulling each leg out
approximately 1˝, then loosen the knob at
the top of the leg assembly and pulls legs
out, extending to full open position so that
the top black bracket slides down until it is
lined up with the red line on the center pole
label. Retighten knob.
Step 2: Using the bolt provided attach the center
handle to the crossbar (Fig. 1).
Step 3: To mount each light fixture to the light bar,
first place plastic spacer on each bolt on the
"U" bracket. Place each bolt through the holes
in the light bar (Fig. 2). Position the knob and
tighten until secure.
Call for customer service and/or missing or damaged parts (800-334-6871)
4/3/06 1:45 PM Page 3
3
cloth.withple Ima
Attach center
handle to
crossbar
Fig. 1
bolt
spacer
Fig. 2