System Information - Lorex L19WD Serie Manual De Instrucciones

AUDIO*
Set volume levels for the two audio inputs of
the system.
To change audio settings:
Mouse:
1. Click and drag the bar left/right to
adjust the volume.
2. Click the radio button to assign audio
recording to one of the four 6-pin DIN
cameras. DIN cameras can only be
connected in channels 1~4.†
Remote Control:
◄►
1. Press to select and audio
channel, then press
the volume.
◄►
2. Press to select the buttons, then
press OK to check.
Click OK to save your settings, or click
DEFAULT to restore factory defaults.
ATTENTION: You can only record two
channels of audio on the system**: one
audio-capable BNC camera or one DIN
camera records audio for channels 1~4; one
audio-capable BNC camera records audio for
channels 5~8. You cannot have a DIN
camera and an audio-capable BNC camera
recording audio at the same time on
channels 1~4.
*Audio capable cameras may not be included with
your system.
**Four audio channels on the L19WD1600.
† Audio control for DIN cameras only available on
L19WD800.
▲▼
to adjust

SYSTEM INFORMATION

View important system information:
• IP Address – The IP address of the system
when on a network.
• MAC Address – MAC address of the
system. Necessary for networking or setting
up remote viewing.
• Disk Capacity – Displays the total size of
the system hard disk and amount presently
in use.
• F/W Version – Firmware version.
• Video Signal Type – Video format of the
system: either NTSC in North America or
PAL in Europe.
• DDNS Domain Name – Domain name used
with the Lorex Client Software to let you
view your system remotely over the Internet
from another PC.
• Net Client Port – The port that allows your
system to communicate to other PCs or
devices over a network. By default, the Net
Client port is 5000.
• Web Server Port – The Web Server port
(by default, 80) to let external PCs or
devices communicate with your system over
the Internet.
L19WD Series
35