EdilKamin BIJOUX Instalación Uso Y Mantenimiento página 48

Environmental temperature control
this comfortable and simple adjustment feature, as standard in
this line of products, allo s you to manage the stove po er
based on the environmental temperature.
After activating the "Comfort Clima" function from the para-
meters menu (ask the technical assistance centre - TAC), press
the SET button brie y a couple of times to s itch from classic
"Modulate_Po er" mode to "Comfort Clima" mode; then
select the desired mode from the display.
Modulate power mode
the stove modulates its po er by follo ing the output tempera-
ture set by the user.
Comfort Clima mode
the stove modulates its po er by follo ing the output tempe-
rature set by the user. You can also use the remote control as a
room thermostat: on reaching the set temperature the stove ill
go to minimum po er.
Setting the environmental temperature
In "Comfort Clima" mode, by pressing the +/- buttons on the
synoptic panel or on the remote control, you can set the display
to the desired environmental temperature.
-At environmental temperatures belo the set temperature, the
stove modulates po er normally to reach the set output.
-With environmental temperature reached (+2°C), the stove
goes to minimum po er.
The environmental temperature is transmitted from the remote
control; the remote control transmitter must be visually aligned
ith the receiver of the synoptic panel
If the remote control is incorrectly positioned, it cannot send
its recorded temperature. The stove therefore independently
decides to operate at minimum po er and continues thus until
the connection ith the remote is restored
Temperature control with external thermostat
another temperature control system is available as an alterna-
tive to the remote control. You can in fact connect the thermo-
stat serial port to your home thermostat or any (clean output
contact) easily available one
The stove ill automatically recognise the connection ith the
thermostat serial port under the follo ing conditions:
With environmental temperature lo er than the thermostat
setting (contact closed), the stove modulates po er normally to
reach the set temperature
-With environmental temperature reached by the thermostat
(contact open), the stove goes to minimum po er
Temperature
Con guration provided by the
remote control
"Comfort
Clima" ON
parameter
"SONDA IR"
ON
parameter
Connection to NO
serial port no connection
INSTRUCTIONS FOR USE
Temperature
provided by
No adjustment
e ternal
(factory setting)
environmental
thermostat
ON ON
OFF ON
Yes
NO
ith blue
no connection
serial cable
T E ELECTRONIC CIRCULATOR
The product ou have purchased is equipped with a circu-
lator with electronic motor.
Electronic control of operation:
a) Control mode p – c
In this mode, the electronic controller keeps the differential
pressure generated by the pump at a constant set value of
b) Control mode p – v
In this mode, the electronic controller varies the pressure
differential bet een the set value s and 1/2
differential varies ith the volume o .
c) Venting procedure
This procedure allo s the e pulsion of air present in the
hydraulic circuit. After manual selection of the "AIR" mode,
the pump ill automatically alternate bet een ma imum and
minimum speed for 10 minutes. At the end of the procedure,
the circulator ill go to the pre-set speed. You can then select
the desired mode of operation
- 48
-
s.
s. The pressure