Handset Sound Signals - GE 28118 Serie Manual Del Usuario

OUT OF RANGE
ROOM MONITORING.... The audio link between handsets is established.
PAGING or
PAGING FROM
REPT
SEARCHING
SPKR
UNKNOWN NAME/
CALLER/NUMBER
Answering System Display Messages
The following messages show the status of the answering system or help you set up and use
the system.
0-59
CL (blinking)
- -
An (blinking)
F (blinking)
Six bars (blinking)
LA (Line Access)

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Three short beeps (several times)
Single beep every 7 seconds
Indicates handset is too far from the base. Move closer to the base.
Someone pressed the page button on the base or del/ intercom/conf
button on the handset
Repeat call message. Indicates that a new call from the same
number was received more than once.
Indicates handset is searching for the base.
Indicates the handset is in speakerphone mode.
The incoming call is from an area not serviced by Caller ID
or the information was not sent.
Indicates the total number of messages.
The voice time/day stamp needs to be set.
Answering system is turned off.
The system is answering a call.
Answering system memory is full.
The system is recording a memo or an announcement.
External line remote answering system.
Meaning
Signals an incoming call
Page signal
Low battery warning
41