Handset Sound Signals; Troubleshooting Guide; Telephone Solutions - GE 21009A Guía Del Usario

Handset Sound Signals

Signal
A long warbling tone (with ringer on)
Three short beeps
One long beep
One short beep (every 7 seconds)
One short beep (during room monitoring) Ring alert tone

Troubleshooting Guide

Telephone Solutions

No dial tone
• Check or repeat installation steps.
• Make sure the base power cord is connected to a working electrical outlet.
• Make sure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack. If it doesn't work, the problem might be
your wiring or local service.
• The handset may be out of range of the base. Move closer to the base
• Make sure the battery is properly charged (for 16 hours).
• Make sure the battery pack (in the handset) is properly installed.
• The handset should beep when you press theTALK/END/call back button, and the
charge indicator on the base should be lit when the handset rests in the cradle. If
not, the battery may need to be charged.
• Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
• Make sure the handset ringer is set to on, this can be done through the handset
setup menu - Ringer Volume.
• The handset may be out of range of the base. Move closer to the base.
• You may have enabled Do Not Disturb (DND). Make sure the DND is off.
• You may have too many extension phones on your line.Try unplugging some
extension phones.
50
Meaning
Signals an incoming call
Page signal
Confirmation tone for the
completion of a function
Low battery warning