Andset Sound Signals; Roubleshooting; Guide - GE 21028 Guia Del Usuario

H S
ANDSET OUND
Signal
A long warbling tone (with ringer on)
Three short beeps
One long beep
One short beep (every 7 seconds)
One short beep (during room monitoring) Ring alert tone
T

ROUBLESHOOTING

T S
ELEPHONE OLUTIONS
No dial tone
• Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the
wall jack.
• Connect another phone to the same jack. If it doesn't work, the problem
might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base
• Make sure the battery is properly charged (for 16 hours).
• Make sure the battery pack (in the handset) is properly installed.
• The handset should beep when you press the TALK/END/CALLBACK
button, and the charge indicator on the base should be lit when the
handset rests in the cradle. If not, the battery may need to be charged.
• Place handset in charge cradle for at least 20 seconds to reset the unit.
Handset does not ring
• Make sure the handset ringer is set to on, this can be done through the
handset setup menu - Ringer Volume.
48
S
IGNALS
G
UIDE
Meaning
Signals an incoming call
Page signal
Confirmation tone for the
completion of a function
Low battery warning