Installation With Latch - Graco ASSURA Manual De Instrucciones

INSTALLATION WITH
1
Place car seat rear-facing
equipped with LATCH
2
Thread LATCH belt through car seat Slots.
Belt must lay flat and not be twisted.
3
For ease of installation, extend
to its maximum length.
4
Hook connectors to vehicle lower anchors
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. b).
5 Press down firmly on car seat to compress
vehicle seat cushion while tightening
belt.
14
LATCH
on vehicle seat
anchors (fig. a).
LATCH belt
LATCH
6
Pull front to back and left to right to check for
secure installation (fig. c).
Check that the lower anchorage belt stays
tight and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Customer Service
(see back cover).
7
Check level indicator on car seat.
Vehicle must be on level ground
and child in car seat when checking level
indicator.
Ball MUST be entirely in green zone (fig. d). If
necessary, place rolled towels under car seat, at
vehicle seat crease, until entire ball is in green
zone. Then re-check level indicator.
8 Adjust handle to a position behind car seat.
Periodically check that car seat is securely
installed and properly leveled; adjust if
necessary.