Rear-Facing Installation With Latch - Graco MySize Manual De Usuario

REAR-FACING INSTALLATION WITH
1. Pull out on handle on front of child
restraint (a) and adjust to
position 1 (b). Make sure
forward-facing
(see fig. c, pg. 40)
2. Place rear-facing
equipped with
3. For ease of installation, extend
LATCH belt to its maximum length.
4. Attach rear-facing
vehicle lower anchors (c). Belt must lie
flat and not be twisted. Pull connectors
to be sure they are securely attached to
the anchor points. (d).
5. Press down firmly in center of child
restraint while pulling
adjustment belt through slot in
seat pad (e). When finished tightening,
make sure free end of adjustment belt is
outside the seating area (f).
rear-facing
LATCH belt is stored.
on vehicle seat
LATCH anchors.
connectors to
LATCH
a
CLICK!
c
Slot
e
20
LATCH
b
d
f