2. Slide the power switch on, and wash the blades in
cold or lukewarm water. After washing, slide the power
switch off, and wipe them dry with a towel or cloth.
3. Place the shaver in an open-air resting place to dry
it thoroughly.
4. Attach the outer foil frame securely to the body
case, and be very careful not to touch the outer foil.
*It is recommended that inner blade be cleaned with the brush at least
once every three (3) washings.
Note on the replacement of the outer foil/inner blade
After replacing the outer foil or inner blade with a new one, refer to step
"3" in "Cleaning with the brush" to attach it properly to the body case.
* For replacement parts, refer to "ACCESSORY PARTS (SOLD SEPA-
RATELY)".
Axis Edge |20| english
Flex-Foil
hood
TM
Flex-Foil
hood
TM
release button
release button
Cleaning with the brush
1. Before cleaning your shaver, be
sure to slide the power switch off, and
press both the outer foil frame release
buttons on the side at the same time
to remove the outer foil frame.
2. Clean the inside of the outer foil,
inside of the outer foil frame, inner
blade and body of the shaver with the
accessory brush.
*To remove the inner blade, pull it
straight upwards.
3. After cleaning, attach the outer foil
frame securely to outer foil frame, tak-
ing care not to touch the outer foil.
Axis Edge |21| english
correct incorrect
Rear Riser
™
11 1