Bosch 1587VS Instrucciones De Funcionamiento página 11

load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
Cleaning
To avoid accidents always
WARNING
!
disconnect the tool from
the power supply before cleaning or
performing any maintenance. The tool may
be cleaned most
compressed dry air. Always wear safety
goggles when cleaning tools with
compressed air.
If an extension cord is
WARNING
!
necessary, a cord with
adequate size conductors that is capable
of carrying the current necessary for your
tool must be used. This will prevent
excessive voltage drop, loss of power or
overheating. Grounded tools must use 3-
wire extension cords that have 3-prong
plugs and receptacles.
NOTE: The smaller the gauge number, the
heavier the cord.
** Vacuum hose
** Hose/vacuum adaptor
** Anti-splinter insert (5pcs.)
** Cutting guide
* Allen wrench 5mm
* Steel footplate insert (1587AVS & 1587DVS)
* Plastic footplate insert (1587AVSK & 1587DVS)
* Carrying case (1587AVSK)
(*= standard equipment)
(**= optional accessories)
effectively with
Accessories
-11-
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
Certain cleaning agents
CAUTION
!
and solvents damage
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia
detergents that contain ammonia.
RECOMMENDED SIZES OF EXTENSION CORDS
120 VOLT ALTERNATING CURRENT TOOLS
Cord Size in A.W.G.
Tool's
Ampere
Cord Length in Feet
Rating
25 50 100 150
3-6 18 16 16
6-8 18 16 14
8-10 18 16 14
10-12 16 16 14
12-16
14 12 —
and household
2
Wire Sizes in mm
Cord Length in Meters
15 30 60 120
14 0.75 0.75 1.5 2.5
12 0.75 1.0 2.5 4.0
12 0.75 1.0 2.5 4.0
12 1.0 2.5 4.0 —
— — — — —