Husky CAT851 Manual De Funcionamiento Y Piezas página 13

Operations & Parts Manual
1 HVLP Gravity Feed Spray Gun
2-3 Cleaning Brush
4 Spanner
5 Socket Wrench
6 1/2" Impact Wrench
7 Hex Key
8 3/8" Ratchet Wrench
9 3/8" Impact Socket 1/2" DR.
10 1/2" Impact Socket 1/2" DR.
11 9/16" Impact Socket 1/2" DR.
12 5/8" Impact Socket 1/2" DR.
13 11/16" Impact Socket 1/2" DR.
14 3/4" Impact Socket 1/2" DR.
15 7/8" Impact Socket 1/2" DR.
16 3" Extension Bar 1/2" DR.
17 Hex Bit Adapter
18 3/8" to 1/2" Adapter
19-38 Bits Set
39 1/4" Air Die Grinder
40-41 Die Grinder Spanner
42-46 1/4" Shaft Grinding Stone
47 Oil Pot
48 Tape Seal
49 Female Plug
50-52 Male Plug
53
Blow Mode Case
1 Surface painting applications
2 Clean spay gun, wash cap
1 Tie-up & loosen the bolt screw nut
1 Tie-up & loosen the nut of Spray gun
1 General fastening applications
1 Tie-up & loosen the cap screw of Impact Wrench
1 A wide variety of fastening application
1 Connected with impact anvil & bolt screw
1 Connected with impact anvil & bolt screw
1 Connected with impact anvil & bolt screw
1 Connected with impact anvil & bolt screw
1 Connected with impact anvil & bolt screw
1 Connected with impact anvil & bolt screw
1 Connected with impact anvil & bolt screw
1 Extended the contact anvil of Impact Wrench
1 Connect with the retched wrench & the bit
1 Tie-up & loosen the bolt screw nut
20 Tie-up & loosen the bolt screw nut
1 Grinding, deburring and sanding operation
2 Tie-up & loosen the grinder collet
5 Grinding in confined area
1 Lubricating oil for air tools
1 Entwine on the thread of inlet to avoid air leakage
1 Connect with air tool & quickly coupler
3 Connect with air tool & quickly coupler
1 House of the air tool & spray gun kit
Model No. CAT851
53
13