Husky CAT851 Manual De Funcionamiento Y Piezas página 3

Operations & Parts Manual
1. Inspect hose connection before each use.
2. Do not exceed 90psi when using pneumatic tools.
3. Do not kink, twist, knot or abrade hose.
Applicable Range:
Is applicable for pneumatic tools and accessories.
Specifications:
Maximum Working Pressure.......90psi.
HVLP Spray Gun Maximum Working Pressure...... 50psi.
WARNING: Do not exceed 90psi air pressure.
Operation
Tool use and care
1. Use clamps or anther practical way to secure and support the work piece to a stable platform.
Holding the work by hand or against the body is unstable and to lead to loss of control.
2. Do not force the tool. Use the correct tool for the application. The correct tool will do the job better
and safer at the rate for which the tool is designed.
3. Do not use the tool if the switch does not turn the tool on or off. Any tool that cannot be controlled
with the switch is dangerous and must be repaired.
4. Disconnect the tool from the air source before making any adjustments, changing accessories,
or storing the tool. Such preventive safety measures reduce the risk of starting the tool unintentionally.
5. Store the tool when it is idle out of children and other untrained persons. A tool is dangerous in the
hands of untrained users.
6. Maintain the tool with care. Keep a cutting tool sharp and clean. A property maintained too, with sharp
cutting edges reduced the risk of binding and is easier to control.
7. Check for misalignment or binding of moving parts, breakage of parts, and any other condition
that affects the tool's operation. If damaged, have the tool serviced before using. Many accidents are
caused by poorly maintained tools. There is a risk of bursting if the tool is damaged.
8. Use only accessories that are identified by the manufacturer for the specific tool model. Use of an
accessory not intended for use with the specific tool model, increases the risk of injury to persons.
9. Accessories must be rated for at least the speed of the tool marked on the tool label. Wheels and
other accessories running over rated speed can fly apart result in a of injury to persons.
Service
1. Tool service must be performed only by qualified repair personnel.
2. When servicing a tool, use only identical replacement parts. Use only authorized parts.
3. Use only the lubricants supplied with the tool of specified by the manufacturer.
Air source
1. Never connect to an air source that is capable of exceeding 115psi. Over pressurizing the tool is
able to result in busting, abnormal operation, and breakage of the tool or serious injury to persons.
Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure
range as marked on the tool. Always verify prior to using the tool that the air source has been
adjusted to the rated air pressure or within the rated air-pressure range.
2. Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool.
Such gases are capable of explosion and serious injury to persons.
USER –MAINTENANCE INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Model No. CAT851
3