Revell Control MOTION PILOT Manual De Instrucciones página 14

Remote control battery safety
instructions:
• Non-rechargeable batteries may not
be charged.
• Rechargeable batteries must be
removed from the remote control
prior to recharging.
• Rechargeable batteries may only be
charged under the supervision of an
adult.
• The combination of different types of
batteries as well as new and used
batteries must be avoided.
• Only recommended batteries or those
of an equivalent type may be used.
• Batteries must be inserted according
to the correct polarity (+ and -).
• Depleted batteries must be removed
from the remote control.
• The connection terminals may not be
short-circuited. Please remove the
batteries from the remote control if
it is not to be used for an extended
period of time.
The helicopter is equipped with
a rechargeable lithium polymer
battery. Please observe the
following safety instructions:
• Never throw LiPo batteries into a
fire or store them in a hot location.
• Only use the supplied charger to
charge the battery. The use of a
different charger may lead to the
permanent damage of the battery
and neighbouring parts, as well as
physical injury!
• Never use a charger for NiCd/NiMH
batteries!
• Always ensure that the charging
process takes place on a fireproof
surface in a fire-resistant environment.
• Do not leave the battery unsupervised
during the charging and discharging
process.
• Never disassemble or alter the battery
contacts. Do not damage or puncture
the battery cells. There is a risk of
explosion!
• The LiPo battery must be kept out of
reach of children.
• When disposing of batteries, they
must be discharged or their capacity
must be fully depleted. Cover exposed
terminals with adhesive tape in order
to prevent short-circuiting!
Safety instructions:
• The product may never be structurally
modified. This may lead to it becoming
damaged or posing a danger.
• Avoid the risk of danger by never
operating the aircraft while sitting on
the ground or in a chair. Operate the
aircraft from a position that allows
easy evasion if needed.
• Always switch off the aircraft and the
remote control after use. Otherwise,
it is possible for the model to be
unintentionally started.
Required batteries for the
helicopter:
Rated output: DC 3.7 V / 0,56 Wh
Batteries: 1 x 3.7 V rechargeable
LiPo battery (integrated)
Capacity: 150 mAh
Charger:
Power supply: DC 5 V from USB port of
a PC or USB hub or directly from the
remote control
Rated output: 4.2 V / up to 500 mA
Battery requirement for the remote
control:
Power supply:
DC 9 V
Batteries: 6 x 1.5 V "AA"
13