BOTTOM AND SIDE DIMENSION
STEP 1
NOTE: Measurements below are drawn in a frameless cabinet with an overlay door.
Find and mark all pre-drill locations
on cabinet by referring to Figure
1A for measurements. Once all
locations have been marked,
Figure 1A
pre-drill using the 1/16" drill bit.
NOTE: If installing into a face
frame or frameless cabinet,
measurements must begin from
the outside edge of the cabinet.
If installing into an inset cabinet,
measurements must begin from
the inside edge of the face frame.
Attach the Inside Frame to the
cabinet floor and cabinet side
walls using (8) 5/32 x 18MM Wood
Screws (See Fig.1B).
Locate the (4) bolts on top of the
Inside Frame and tighten to lock
into place.
Attach Adjustable Side Bracket to
the cabinet wall using (3) 5/32 x
18MM Wood Screws (See Fig. 1B).
1
16
Figure 1B
NOTE: Use a level to ensure balance.
2
Customer Service: 800-626-1126 | rev-a-shelf.com