Publicidad
Figure 7
STEP 7
Locate the (4) pre-tapped holes on
Right Side
the Swivel Frame. With the knobs
facing outward, attach the Top
Bracket and the Bottom Bracket to
the Swivel Frame using (4) M4x6
Flat Head Screws.
NOTE: Top Bracket is attached
to the uppermost holes on the
Swivel Frame.
With the thinner portion of the
Gas Spring pointing down, snap
the Gas Spring into position using
the knobs on the Top and Bottom
Brackets (See Fig. 7).
NOTE: Ensure the thinner
portion of the Gas Spring is
pointing down.
VERITCAL ADJUSTMENT
Cycle the unit a few times. If the
guide channel is not functioning
efficiently, vertical adjustments
can be made by loosening the
(4) fasteners at the top and
Figure 7B
bottom. Securely re-tighten once
adjustments have been made
(See Fig. 7B).
Left Side
6
Customer Service: 800-626-1126 | rev-a-shelf.com
Publicidad
