Publicidad
STEP 4
Find and mark all door panel
mount hole locations by referring
to Figure 4A for measurements.
Once all locations have been
marked, pre-drill using the 1/16"
drill bit.
NOTE: All door mount locations
must be in the thick portion of
the door.
Fit the Up Bracket into the top of
the Door Frame and the Down
Bracket into the bottom of the
Door Frame.
Attach the Door Frame to the back
of the door using (4) 5/32 x 18MM
Wood Screws (See Fig. 4B).
Tighten all (8) pre-installed
fasteners using Phillips Head Screw
Driver.
1
16
STEP 5
Remove all (4) screws from the
arms of the Door Frame and slide
the arms into the Swivel Frame
(See Fig. 5). Secure using the (4)
screws.
NOTE: These are the door tilt
adjustment screws.
4
Figure 4A
Figure 5
Customer Service: 800-626-1126 | rev-a-shelf.com
Figure 4B
Remove Screws
Publicidad
