BaByliss PRO BAB2472TDE Manual Del Usuario página 5

INSTRUCTIONS FOR USE
• Plug the unit in and press on the
'I' button. The iron will begin to
heat up. Set the temperature
using the selector. The red
indicator light will flash for a
while until the unit reaches the
desired temperature. When the
light is fixed, the unit is ready to
use.
• Divide dry or damp hair into
equal sections and comb before
curling. Press on the clamp lever,
place the iron halfway along the
section of hair and spread the
hair evenly between the clamp
and the barrel. Pull the iron
gently to the end of the hair. To
prevent crimps, make sure the
hair is properly coiled under the
clamp, in the direction of the curl.
Place the clamp on top of the
section to curl the hair under. To
curl the hair out, place the clamp
underneath the section.
• Coil the hair up to where you
want the curls to start, being
careful not to touch the scalp
with the barrels. Keep the iron
in place for 5 to 8 seconds. For
tighter, bouncier curls, work
with only a little hair at a time.
For looser, softer curls, work with
more hair.
• To remove the iron, press on the
clamp lever and pull the iron out.
Wait until the hair has cooled
before brushing or combing to
allow the curls to 'set'. For best
results, we recommend using
BaBylissPRO® styling products.
• After use, press the '0' button
and unplug the unit. Wait until
it has cooled completely before
putting it away.
• If the unit remains unused for
longer than about 72 minutes,
the auto shut-off will turn the
unit off; this option increases the
life of the barrels and provides
greater safety.
MAINTENANCE
Once unplugged and cooled, the
iron may be wiped with a damp
cloth. Make sure it is completely
dry before plugging it in again.
WARNING
The barrel becomes very hot in a
few seconds and should not touch
skin once plugged in. This iron
becomes extremely hot when
set to the highest temperature.
Always test the iron on a section of
hair to make sure that the setting
is appropriate for the hair.
5