Installation; Operation - Omnitronic CDP-386 Manual Del Usuario

5. INSTALLATION

Install the CD-player on a plane surface or in your rack.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the CD-player into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the CD-player with four screws M6 in the rack.
Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure
safety, additional fastening by using ground and side bars is necessary.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.

6. OPERATION

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
6.1 OPEN/CLOSE
Press OPEN/CLOSE in order to open the disc tray. Insert your CD. Press the OPEN/CLOSE BUTTON again
in order to close the tray.
Once the tray is closed, the player begins to read the CD information.
Press PLAY/PAUSE to start playback.
You can also choose the desired track with the Skip-buttons.
6.2 SKIP
In order to select the desired song press one of the Skip-buttons until the desired track-number is displayed.
The player will start the song from the beginning.
6.3 PLAY/PAUSE
Press the PLAY/PAUSE BUTTON in order to start playback. Press the PLAY/PAUSE BUTTON once more in
order to stop playback.
6.4 SYNCHRONISATION
You can synchronise the two CD players while cueing with the headphones via the mixer.
Method:
Press the Play/Pause-button of player 1.
Press the Play/Pause-button of player 2.
Use your headphones for cueing.
Only use the Pitch-button of Unit 2.
23/48 1060225E_V_1_0.DOC