Electrical Safety - Stanley FatMax FME365 Manual De Instrucciones

Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool: :
Warning! To reduce the risk of injury, the user must
read the instruction manual.

Electrical safety

#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
Using an extension cable
Always use an approved extension cable suitable for the
power input of this appliance (see technical data). The
extension cable must be suitable for outdoor use and marked
accordingly. Up to 30 m of 1.5 mm2 HO5VV-F extension cable
can be used without loss of product performance. Before use,
inspect the extension cable for signs of damage, wear and
ageing. Replace the extension cable if damaged or defective.
When using a cable reel, always unwind the cable completely.
(Original instructions)
Features
This tol includes some or all of the following features.
1. Adjustable shoe
2. Blade clamp collar
3. Pendulum selector switch
4. Variable speed on/off switch
5. Shoe release button
Assembly
Warning! Before attempting any of the following operations,
make sure that the tool is switched off and unplugged and that
the saw blade has stopped. Used saw blades may be hot.
Fitting the saw blade (fig. B)
Hold the tool away from the body
u
Rotate the blade clamp collar (2).
u
Insert the shank of the blade (6) fully into the blade clamp
u
collar (2).
Release the blade clamp collar (2) to lock the blade into
u
position
Note: The blade can be installed with the teeth up to assist in
flush cutting
Removing the saw blade (fig. B)
Warning! Burn hazard: Do not touch the blade immediately
after use. Contact with the blade may result in personal injury.
Rotate the blade clamp collar (2) to the release position
u
Remove blade (6)
u
Adjustable shoe (fig. C)
The shoe (1) will adjust to limit the depth of cut.
Press the shoe release button (5)
u
Slide the shoe (1) to the desired position
u
Warning! To prevent loss of control, never use tool without
shoe.
Use
Switching on and off (fig. D)
The variable speed on/off switch offers a choice of speeds for
greatly improved cutting rates in various materials.
To switch the tool on, squeeze the variable speed on/off
u
switch (4).
To switch the tool off, release the variable speed on/off
u
switch (4).
ENGLISH
5