Adjusting The Inclination Of The Footplates; Fitting/Removing The Self-Propelling Wheels (Optional); Accessories (Optional) - Invacare Aquatec Ocean Manual De Instrucciones

Assembly and installation

Adjusting the inclination of the footplates

IMPORTANT
The inclination of the footplates is continuously adjustable.
▸ Set the right and left footrest in the exact same way.
1. Loosen the Allen head screw
key.
2. Turn the footplate to the desired position.
D
3. Retighten the Allen head screw.
4.3 Fitting/removing the self-propelling wheels
(optional)
on the footplate using a size 4 Allen
C
Shower and Toilett Commode Ocean / Ocean XL
IMPORTANT
▸ When the self-propelling wheels are fitted, the rear wheels
must remain locked.
▸ The assembly is the same for the right and left self-propel-
ling wheel.
▸ The hubs and the parking brakes for the self-propelling
wheels must be fitted by a dealer. Assembly is described in
the assembly instructions „Assembling the hubs and brakes
for Aquatec®Ocean 24" wheels".
1. Align all four wheels in the driving direction.
2. Lock all wheels.
3. Push the axle on the self-propelling wheel inwards.
D
(The handrims project outwards.)
4. Press and hold the button
This releases the retaining balls
5. Raise the shower and toilet commode a little.
6. Insert the axle into the hub
onto the axle until the end stop E.
7. Release the button.
8. Press the retaining balls outward so that they are behind the
hex nut A.
Remove the wheels using the same procedure in the reverse order.

4.4 Accessories (optional)

WARNING
▸ The assembly of accessories (optional) must be carried out
according to the corresponding instructions.
on the outside of the axle.
F
at the end of the axle.
C
and push in the self-propelling wheel
B
11