Power Connection; Application And Operation; Storage; In Case Of Problems - STORZ & BICKEL Mighty Modo De Empleo

6.2. Power Connection

Before connecting up the Vaporizer,
make sure that the information given
on the power adapter type label corre-
sponds to the local power supply volt-
age.
All parts of the electrical system must
comply with currently applicable offi-
cial regulations.
Place the heated Vaporizer only on a
hard, stable surface, and not on any
soft or heat-sensitive material.
Take care that the power adapter cord
cannot be damaged through kinking,
crushing or pulling.
Improper installation may lead
to personal injury or material
damages, for which the manu-
facturer cannot be held responsible.

6.3. Application and Operation

This Vaporizer was developed
for vaporizing the plant materi-
als listed in the plant overview.
Any other use is inappropriate and po-
tentially dangerous.
The user should always follow the in-
structions listed here for use and main-
tenance.
If you have any concerns, or if there are
any problems immediately switch off
the Vaporizer and pull the power adapt-
er cord, if used, from the socket. Do not
try to remedy the defect yourself. Con-
tact our Service Center directly.
6 . T H E M I G H T Y VA P O R I Z E R
After using the Vaporizer and power
adapter, allow them to cool down be-
fore placing them in storage.

6.4. Storage

Store the Vaporizer and the power
adapter in a dry place protected
against the effects of weather and out
of the reach of children or unqualified
persons.

6.5. In Case of Problems

If the power adapter has been in use,
unplug it at the socket and ensure that
no one can connect the Vaporizer to
the mains supply again without this
being noticed.
Before any maintenance work is done,
the Vaporizer has to be switched off
and the power adapter unplugged
from the power supply.
Put the Vaporizer in the original pack-
aging, or pack it properly in other pack-
ing material, and send it to our Service
Center.
47