Cleaning The Mighty Cooling Unit; Removal Of The Lower Filling Chamber Screen - STORZ & BICKEL Mighty Modo De Empleo

10. D I S A S S E M B L I N G , C L E A N I N G A N D A S S E M B L I N G
10.2. Cleaning the MIGHTY Cooling
Unit
The Cooling Unit can be disassem-
bled for cleaning purposes and then
assembled again (see Chapter 10.1.
"Disassembling and Reassembling the
MIGHT Y Cooling Unit", page 58).
The Cleaning Brush, cotton swabs and
paper or cotton towels may be used for
cleaning. As solvent, we recommend
alcohol (ethanol) or warm water with
wash-up liquid.
For optimal airflow, please ensure the
Cooling Unit and Mouthpiece are clean
and free from debris blockage.
Manual cleaning of the disassembled Cooling
Unit
Do not immerse any plastic
components in alcohol or eth-
anol for longer than an hour.
Extended contact with alcohol or etha-
nol can lead to discoloration or embrit-
tlement of plastic parts.
Before assembling allow all compo-
nent parts to dry properly.
After cleaning, check all component
parts for surface damage, tears, sof-
tening or hardening, impurities, distor-
tion and discoloration and set dam-
aged component parts aside.
Warning! Alcohol (ethanol) is
flammable and may easily ig-
nite.
Sets of new Cooling Units may
be ordered from www.storz-
bickel.com.
10.3. Removal of the Lower Filling
Chamber Screen
Remove the lower Filling Chamber
Screen using the Filling Chamber
Tool by pushing in along the indenta-
tion of the Filling Chamber. In this way
the Screen arches and detaches itself
from the notch.
Inserting a new Screen: It is easier to
insert the Screen if it was previously
curved and inserted with the curved
side facing up. Using the Filling Cham-
ber Tool, you can press the screen flat
so that the edges of the screen seat
into the groove at the bottom of the
Filling Chamber.
60