BaByliss PRO 4ARTISTS REDFX FX8700RE Manual Del Usuario página 6

ENGLISH
Please carefully read the safety
instructions before using the
appliance.
adaptateur
Vibrations
LpA (dB(A))
PROFESSIONAL CORD/
CORDLESS CLIPPER
EDM TECHNOLOGY
OPERATING INSTRUCTIONS
1. Before using the clipper for the
first time, charge continuously
for 3 hours. Maximum battery
capacity will only be reached
after 3 charging and discharging
cycles.
2. Make sure the switch on the
clipper is in the OFF position.
Connect the charging jack into
the receptacle on the bottom
of the clipper. Plug the adapter
into any electrical outlet (at
the voltage listed on the label
affixed to the adapter). The
charging indicator will light
up red to indicate that the
charging has begun. Charging is
complete after 3 hours.
3. The adapter may become warm
while charging. This is normal.
4. Preserving the batteries: In
order to maintain the optimum
capacity of the rechargeable
CA78M
< 2,5 m/s²
< 70
batteries, the clipper should
be recharged for 3 hours
approximately every 6 months.
5. Make sure the switch is in the
OFF position when the clipper is
not operating.
6. If the charging light starts to
flash rapidly (more than 4 flashes
per second) then the appliance
is faulty. If this happens then
please stop
remove the adapter from the
mains and contact an authorized
Service Center.
FOR DIRECT PLUG-IN OPERATION
Make sure clipper is off. Connect
charging jack into the receptacle
at the end of clipper and plug the
adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch
to ON (marked «I»). To stop
operation, set to the OFF (marked
«0») position.
VERY IMPORTANT: Blades must
be cleaned and oiled on a regular
basis for proper functioning.
Failure to regularly clean and oil
the blades will void the warranty.
USER MAINTENANCE
INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades
before and after use. This will
ensure maximum cutting
performance
maintenance. Hold the clipper
6
charging and
and proper