Publicidad
Idiomas disponibles
Idiomas disponibles
install crossbars
Slide bar clamp into
frame end, through
bar guide.
DO NOT TIGHTEN.
assemble pods and skewers
Remove
pod covers.
Assemble two
halves of pod
loosely onto
crossbar.
Single screw hole
indicates FRONT.
Attach pod cover.
1032445C-3/18
Insert crossbars through frame ends,
bar guides and bar clamps. Center bars.
Keep bars at least 2" away from vehicle.
INSTALL
PODS
Insert skewer while applying
pressure to pod cover.
Pod covers
must be in
place at all
times for safe
operation of
bike carrier.
Skewer direction is your choice;
consider lock access.
Position pod so front
dips slightly.
Install pods so
bikes load in
opposite
(looking from side view)
directions.
INSTALL SKEWER
INSTALL END
CAPS by pushing
end caps onto
ends of
crossbars.
Tighten until round bars cannot rotate.
DO NOT OVER TIGHTEN.
SECURE PODS
Tighten the screws using
the supplied hex wrench.
The pod must not rotate!
Tighten until there is no
longer a gap between
pod halves.
FRONT
ATTACH SKEWER NUT.
Leave plenty of skewer showing.
Tighten bar clamps
using the hex wrench.
Publicidad
