Publicidad
Idiomas disponibles
Idiomas disponibles
install locks in levers
Remove the housing cap.
Insert the Control Key into the
core, and install lock.
RECORD YOUR KEY NUMBER:
assemble wheel trays
Compress the
strap into the
red button
slots.
1032445C-4/18
IMPORTANT—
located on the set of
silver-toned keys.
Insert the carriage bolt
vertically into the
lower hole.
Pry open the
bracket and
attach to bar.
You may need to rotate the
small hole inside the lock
housing so that the point on the
lock core will align.
The number is
Place wheel tray and
bolt into bracket.
Attach hex key but
do not tighten.
Push the core into the housing.
Hold the core with the tip of your thumb as you
pull out the gold Control Key.
If your key becomes lost, you
can order another key by
calling 888-925-4621.
attach reflector
INSERT THE LINER
INTO THE CLAMP.
Pry open clamp and
liner, attach to end of
driver side bar.
• Install reflector.
• Use a screwdriver to Tighten
reflector clamp.
The lock
should remain
in the housing.
Publicidad
