GYS PACK OBD Manual De Instrucciones página 9

Translation of the original instructions
If the equipment or the vehicle connected to the GYSPACK OBD needs more than 4A or has a short
circuit, the electronic protection of the GYSPACK OBD will switch on and cut the power supply. To use
it again and enable the protection, it is necessary to disconnect the 12V DC plug or the GYSPACK OBD.
USE ON OBD PLUG
Before using this feature you must be sure that all the energy consumers of your vehicle (fan, lights, onboard compu-
ter...) are switched off:
1 - Check the internal battery of the GYSPACK OBD is charged (read « Test of the internal battery»).
2 - Connect the cable with the OBD connector to the vehicle.
 Check that the connector is properly plugged into the vehicle.
3 - Switch on the product.
4 - Disconnect the battery from the vehicle and put the cables on a non conducting surface.
Attention: The electrical system of the vehicle receives current from the OBD Memory Saver via the OBD plug. However
the battery terminals are still supplied with power. It is necessary to insulate them and avoid any contact with a metallic
part or any conducting object which can create a short circuit.
5 - Once the battery is connected to the vehicle, disconnect the OBD plug.
6 - Charge the product after use.
USE AS A 12V POWER SUPPLY VIA THE CIGARETTE LIGHTER PLUG
This product gives you a 12V power supply via the cigarette lighter plug:
1 - Check the internal battery of the GYSPACK OBD is charged (read « Test of the internal battery»).
2 - Check the equipment that you want to connect to the GYSPACK OBD is switched off then connect the unit via the
cigarette lighter connection.
3 - Switch on the equipment. The GYSPACK OBD will supply the power needed.
4 - Switch off the equipment after each use, disconnect the cigarette lighter connection and plug the GYSPACK OBD
into the mains supply to charge it.
Important: Do not use the OBD plug as a power supply for the on board electronics (onboard computer, radio) because
you can damage the internal battery.
NO WARRANTY ON THE BATTERY
The internal batteries are active components; their life depends on your use and maintenance. The internal batteries
must be charged after EACH use. High temperatures will considerably reduce the battery charge. After a long period
without using the Gyspack OBD, it is recommended to charge the internal batteries again before using.
For this reason the Gyspack OBD battery is not covered under the warranty.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
GYSPACK OBD EN
9