GE 20 Serie Manual Del Propietario E Instalación página 26

REVERSING THE DOOR SWING
REHANG REFRIGERATOR DOOR
6
Lower the refrigerator door onto the center
A
hinge pin. Ensure that the plastic hinge pin
thimble is on the center hinge pin or inside
door hinge pin hole located in the bottom
of the door.
Insert the door thimble into the hinge hole on
B
top of the refrigerator door and then insert the
top hinge pin. Make sure the door is aligned
with the cabinet. Attach the hinge to the top of
the cabinet loosely with the bolts.
Make sure the gasket on the door is flush
C
against the cabinet and is not folded. Support
the door on the handle side and make sure the
door is straight and the gap between the doors
is even across the front. While holding the door
in place, tighten the top hinge bolts. Replace
the hinge cover.
Installation Instructions
(cont.)
26
INSTALL THE LOGO BADGE
7
Remove the adhesive backing paper and align
the pins on the back of the badge with the
holes in the door. Apply pressure to the badge
to ensure it sticks to the door.