SOMFY Passeo 500 Manual Del Usuario página 22

Parametering your PASSEO/AXOVIA
2
•
Memorising the remote controls:
On each remote control, the first button memorized will control leaf opening completely.
Place the remote control against the target engraved on the hood and do the following
operations :
1
Maintain the button to be memorized
pressed until the PROG light blinks slowly
(the DANGER light lights up during this
operation)
Release the button : it is
2
memorized.
Repeat these operations for :
• the second button (pedestrian
opening),
• the other remote controls to be
memorized.
At the end of the memorization cycle, only the PROG and ON/OFF lights are lit, the
electronics waiting for memorization of leaf displacement
•
Memorisation of leaf displacement :
The Somfy electronics automatically memorizes :
• The force of the cylinders necessary for gate control in normal operation. This
memorization then makes it possible to detect any abnormal force on the motorization.
• The angles necessary for complete opening and closing of the gate leaves with
locating the stops. This memorization then makes it possible to slow down before
reaching on the stops.
In order to start up the memorization process with the LEAF CLOSED, stand at a normal distance from
the gate and respect the following steps :
1
• Push on the programmed button
designed for complete opening.
>After a few seconds, the gate
opens at low speed.
2
• Once the gate is open, push again on
the same button.
>The gate closes, one leaf after the
other.
PROG
AUTO
ON/OFF
STOP
Parametering your PASSEO/AXOVIA
2
3
Push again on the same
button.
>The gate opens, still at low
speed.
4
• Push a last time.
>Both leaves close almost
simultaneously.
At the end of these 4 steps, the PROG light turns off, indicating the end of the gate
displacement memorization procedure.
This cycle must be complete (2 complete, uninterrupted openings/closings). If it is
interrupted, the process is simply postponed and will be taken up again at the next
controlled opening.
• Check the pedestrian mode (leaf covering M1) :
STOP
• Push on the second button.
>Only the covering leaf should open. A
new push on this same button
controls closing the leaf.
Your gate is now ready to operate. Push on the remote control button, your
gate opens automatically. Push again and it closes behind you.
STOP
S
22