Leroy-Somer Nidec POWERDRIVE MD Instrucciones De Manipulación página 14

● Assembly and dismantling of the IP54 cover
Assembly: 1 - Remove the 4 rings or the 2 lifting rails.
2 - Complete the cover casing following the diagrams below.
The non-slatted side panels are assembled on opposite sides; there are no slats
at the rear of the drive.
3 - Screw the M12 screws provided on the cover casing.
4 - Adjust the cover casing to optimise the seal.
5 - Give the fastening screws a final tightening (tightening torque: 20 N.m).
Dismantling: Reverse the procedure.
T1,T1E
14
HANDLING INSTRUCTIONS
T2,T2E
T4
T3
T6
Handling instructions
3919 en - 2019.02 / e