Lighting - Broil King 956084 Manual Del Usuario

LIGHTING

BASIC GAS GRILL COMPONENTS
A. Main burner controls
B. Side burner control
C. Rear burner control
LIGHTING INSTRUCTIONS
•
The grill must be assembled and installed as per the
assembly and installation instructions
•
Ensure the grill is properly connected to the LP or
Natural Gas supply. See: "Hose and Regulator." (Page
11)
•
Ensure there are no gas leaks in the gas supply
system. See: "Leak Testing." (Pages 13)
•
Ensure that the venturi tubes are properly located over
the gas valve orifices. See Venturi diagram, (Page 14)
•
Ensure that Main Burner, Side Burner and Rear Burner
ignition wires are connected
•
Check that the battery has been installed in the
electronic ignition
•
Carefully review all instructions on the information
plate attached to the gas grill
1. Open lid before lighting
2. Do not lean over gas grill while lighting.
3. Set control knobs to "OFF" and turn on the gas supply.
LIGHTING THE MAIN BURNER:
To light burner with the ignitor:
4. Push and turn one main burner control knob to "HIGH."
5. Push and hold down the ignitor.
6. Burner should ignite within 5 seconds; turn off gas
source immediately if ignition does not occur in this
timeframe.
To light burner with a match:
4. Use the match holder and, apply lit match to burner
port.
5. Push and turn right main burner control knob to "HIGH."
6. Burner should ignite within 5 seconds; turn off gas
source immediately if ignition does not occur in this
timeframe.
7. After the first burner is lit, push and turn the adjacent
main burner control knob to "HIGH" then repeat for
other burners; these burners should light automatically
without the ignitor.
Note: In windy conditions, ignite each burner individually.
D. Ignitor
E. Handle
LIGHTING THE SIDE BURNER:
To light burner with the Ignitor:
4. Push and turn side burner control knob to "HIGH."
5. Push and hold the ignitor button.
6. Burner should ignite within 5 seconds.
To light burner with a match:
4. Apply lit match to burner ports.
5. Push in the side burner control knob and turn to "HIGH."
6. Burner should ignite within 5 seconds.
Note: Pots on the side burner must not exceed 9" (23 cm)
in diameter or 15 lbs. (7 kg) in weight.
LIGHTING THE REAR ROTISSERIE
BURNER:
Warning: do not operate the main burner simultaneously
with the rear burner.
•
REMOVE THE WARMING RACK
To light burner with the Ignitor:
4. Push and turn rear burner control knob to "HIGH."
5. Push and hold the ignitor button.
6. Burner should ignite within 5 seconds.
To light burner with a match:
4. Apply lit match to burner ports.
5. Push in the rear burner control knob and turn to "HIGH."
6. Burner should ignite within 5 seconds.
CAUTION: Check your gas grill after lighting. All burner
ports should show a 2.5cm / 1" flame on "HIGH."
If any of the following symptoms occur there is
probably a blockage in the venturi tubes. Shut off gas
at once and clean the venturi tubes. See "Venturi
Tubes" (Page 14).
•
You smell gas
•
A flashback fire occurs
•
Your gas grill heats unevenly
•
The burners make popping noises
IF BURNER DOES NOT IGNITE:
•
Push and turn control knob to "OFF." Wait 5 minutes
then try again with control knob set at "MEDIUM"
•
If any burner will not light, see "Troubleshooting" on
page 21. If problem persists, do not attempt to
operate the appliance; contact OMC, your dealer or an
approved service center
SHUTDOWN:
1. Turn LP gas cylinder valve or gas supply valve off.
2.
Turn control knobs to "OFF."
15