Leak Testing - Broil King 956084 Manual Del Usuario

LEAK TESTING

All factory-made connections have been carefully tested for
gas leaks. However, shipping and handling may have
loosened a gas fitting.
AS A SAFETY PRECAUTION:
• Test all fittings for leaks before using your gas grill
• Test for leaks every time you disconnect and
reconnect a gas fitting, at least once per year or
after any period of nonuse
• Do not smoke while testing
• Never test for leaks with a lit match or open flame.
• Test for leaks outdoors
TO TEST FOR LEAKS:
1. Prepare a soap solution of one part water, one part
liquid detergent.
2. Extinguish any open flame or cigarettes in the area.
3. Make sure that gas grill valves are "OFF."
4. Make sure that cylinder valve or the gas supply valve is
"OFF."
5. With a full gas cylinder, open cylinder valve slowly. Or
open gas supply valve.
6. Brush the soap solution on each connection.
7. A leak is identified by a flow of bubbles from the area
of the leak.
8. If a leak is detected, close the gas cylinder valve or the
gas supply valve, tighten the connection and retest.
9. If the leak persists, contact your gas grill dealer for
assistance. Do not attempt to operate appliance if a leak
is present.
If your gas grill is equipped with a side burner or
rear burner:
1. Follow steps 1 - 5 above
2. Place fingertip over the opening in the orifice at the
end of hose.
3. Turn "SIDE"/"REAR" control to "HIGH."
4. Brush soap solution on each connection between
orifice and control valve.
5. Turn "SIDE"/"REAR" control to "OFF".
A. GAS SUPPLY PIPING
B. QUICK DISCONNECT COUPLING
C. ADAPTER FITTING
D. EXTENSION HOSE ASSEMBLY
E. LEAK TEST HERE
13